Re: First StuG photos! [TANKS]

["Marc en Wendy" <marcmethorst-at-zonnet.nl>]

Chris,

 

Looking fine again ... I wondered what scale you're building because my tank is a bit bigger than 1:6 to stick to the 36" rule. I found it very difficult to fit everything inside the small tank.

What will be the dimensions of the StuG roughly?

 

Marc

----- Original Message -----

From: chris barthelson

To: tanks-at-rctankcombat.com

Sent: Friday, August 05, 2005 1:44 AM

Subject: First StuG photos! [TANKS]

Hi all,
I have finally got some work done on the Stug III Ausf. G.

>Will you be doing a step by step (with photo's) on your suspension?

Yes. I'll start now.

001 shows my progress so far (I do have the wheels, just not in this photo).

003 shows the bolts that will be attached to the springs. It also shows the 
Acetal bushings I made.

005 shows the shafts (kinda blury) and the bushings. This is where the arms 
will be welded. I used 3/8" rod because that's what I had laying around. 
5/16" would be enough I think.

Chris. b

_________________________________________________________________
SEEK: Over 80,000 jobs across all industries at Australia's #1 job site.   
http://ninemsn.seek.com.au?hotmail

001.JPG

003.JPG

005.JPG